SPEED=LOW, OUT=OFF, FLEN=OFF, MUXNEG=PIN0, MUXPOS=PIN0, HYST=HYST50, INTSEL=TOGGLE
Comparator Control n
| ENABLE | Enable |
| SINGLE | Single-Shot Mode |
| INTSEL | Interrupt Selection 0 (TOGGLE): Interrupt on comparator output toggle 1 (RISING): Interrupt on comparator output rising 2 (FALLING): Interrupt on comparator output falling 3 (EOC): Interrupt on end of comparison (single-shot mode only) |
| RUNSTDBY | Run in Standby |
| MUXNEG | Negative Input Mux Selection 0 (PIN0): I/O pin 0 1 (PIN1): I/O pin 1 2 (PIN2): I/O pin 2 3 (PIN3): I/O pin 3 4 (GND): Ground 5 (VSCALE): VDD scaler 6 (BANDGAP): Internal bandgap voltage 7 (DAC): DAC output |
| MUXPOS | Positive Input Mux Selection 0 (PIN0): I/O pin 0 1 (PIN1): I/O pin 1 2 (PIN2): I/O pin 2 3 (PIN3): I/O pin 3 4 (VSCALE): VDD Scaler |
| SWAP | Swap Inputs and Invert |
| SPEED | Speed Selection 0 (LOW): Low speed 1 (MEDLOW): Medium low speed 2 (MEDHIGH): Medium high speed 3 (HIGH): High speed |
| HYSTEN | Hysteresis Enable |
| HYST | Hysteresis Level 0 (HYST50): 50mV 1 (HYST70): 70mV 2 (HYST90): 90mV 3 (HYST110): 110mV |
| FLEN | Filter Length 0 (OFF): No filtering 1 (MAJ3): 3-bit majority function (2 of 3) 2 (MAJ5): 5-bit majority function (3 of 5) |
| OUT | Output 0 (OFF): The output of COMPn is not routed to the COMPn I/O port 1 (ASYNC): The asynchronous output of COMPn is routed to the COMPn I/O port 2 (SYNC): The synchronous output (including filtering) of COMPn is routed to the COMPn I/O port |